
258 Planning and Installation Guide ShoreTel 14.2
Installing ShoreTel Voice Switches Installing the Retainer
13
Installing the Retainer
1. Using a number 1 Phillips screwdriver, remove the two black Phillips head screws on either side of
the RJ-21X port.
2. Place the retainer in the recessed area around the RJ-21X port.
3. Reinstall the two screws.
4. Plug in the RJ-21X cable.
5. Pull the velcro strap tightly around the connector on the RJ-21X cable, and fasten it.
Virtual Switches and Service Appliances
This section describes the following virtual devices:
ShoreTel Virtual Phone Switch (vPhone Switch)
ShoreTel Virtual Trunk Switch (vTrunk Switch)
ShoreTel Virtual Service Appliance (SA-vCollab)
These virtual devices get delivered as separate OVA files and are part of the system installation on the
Headquarters Server and the DVS.
You deploy a virtual device by using a VMware vSphere client on a vSphere ESXi server.
Default Configurations
The installation process creates default configurations for Shortel virtual switches and service
appliances.
Memory: 2 GB
CPU/Cores: 1 socket, 4 cores
Hard disk: 100 GB, thin provisioned
Video card: 1 display, 4 MB video memory, no 3D support
SCSI controller: BusLogicParallel
Network adapter: vmxnet3 (VM network)
Note
For recommended virtual service appliance capacities, see Chapter 6, Configuring the Service
Appliance, in the Conferencing and Instant Messaging Planning and Installation Guide.
Kommentare zu diesen Handbüchern